MXR

In 1982 Tom Scholz, founder of pioneering hard rock band Boston, designed and released the Rockman X100 headphone amp through his company Scholz R&D. It was more than just a headphone amp, with recording console connectivity and several tone tweaking features and built-in effects - the X100 became the secret weapon in the studio that would go on to define the polished, chorus-laden sound of 1980s arena rock. The MXR Rockman X100 revives the signature sonic character of the original amp in a stomp box form. The MXR design team captured the same crystalline cleans, crunchy harmonics and shimmering modulation of the original. With the same four tonal presets, carefully calibrated compression and bucket-brigade chorusing, this all-analog recreation also features both mono and stereo modes and optional external mode switching for an enhanced user experience. Buffered bypass. Cannot be powered by a battery. Supplied with AC adaptor.

• Two independent analog octave voices
• Mid+ switch boosts selectable midrange
• Constant headroom Technology (CHT)

• Separate INPUT & OUTPUT level controls
• 3-band EQ section with sweepable midrange
• Studio-quality Direct Out

• Overdrive pedal made exclusively for bass
• Get big, punchy, tubelike bass tone
• Volume, Tone, and Drive controls
• Clean control lets you blend your clean signal in with the overdrive
• Compact, pedalboard-friendly form factor
• Powered by one 9V battery or AC adapter (not included)

• Vintage Echoplex EP-3 tape echo warmth and modulation
• Audiophile quality audio paths
• 100% analog dry path
• Studio-grade low noise floor
• Age control varies delay tone from pristine to dark and dirty
• Delay control provides 65–750ms of delay time
• Tap jack provides up to 4 seconds of delay time with external Tap Tempo Switch
• The Echoplex Delay requires 9 volts (240mA) and can be powered by the included Dunlop ECB003/ECB003EU adapter or the Iso-Brick ™ Power Supply. This pedal cannot be powered by a battery.
• To combine the EP103 with the EP101 Echoplex Preamp for the full Echoplex EP-3 experience, simply run the EP101 in front of the EP103

• Hand-wired circuit board built with original-spec 1974 components
• Warm analog tone
• Select resistors paired with hand-matched FETs
• Adorned with script logo
• Simple one-knob operation
• Deep, rich phasing

• Classic studio compressor in a Phase 90-sized pedal
• CHT™ Constant Headroom
• Technology for clear, clean performance
• Ten Gain Reduction status LEDs
• True bypass
• The MXR Studio Compressor is powered by one 9-volt battery (remove bottom plate to install), a 9-volt AC adapter such as the Dunlop ECB003/ECB003EU, or the DC Brick™ and Iso-Brick™ power supplies.

• Compact chorus effect pedal
• All-analog circuitry with bucket-brigade technology
• Offers a wide range of rich chorus textures
• True-bypass circuitry keeps your tone intact

Every effect a bass player could ever need in one compact box: distortion channel with gain, volume and blend controls; noise gate switch with trigger control. The clean channel features a colour switch with bass, mid and treble controls. 

Adds dimension and dynamics to Zakk's legendarily blazing solos and razor sharp leads; all with the twist of a single rate knob. Take it from a slow grind to a jack hammering pulse, or use it as Zakk does, at the 9 o'clock position for a slow burning sweep. Jack your tone into another dimension.
Hardwire bypass. Powered by 9 volt battery or AC adaptor.

• Versatile signal switching to multiple amps, with different effects configurations
• Thru output for a constant signal
• Heavy duty housing

• 100HZ cut and boost control allows tonal fine-tuning
• BUMP switch engages alternate voicing for a low and mid-range boost
• True Bypass

• Wet and dry controls let you mix your tone to taste
• Designed to preserve the fundamental spunch & clarity of your bass
• Unique distortion circuitry based on a modified fuzz pedal